Headlight Restoration Kit
Make your Headlights / Tail-lights look new AGAIN !
Our product consists of 3 steps with 3 different products to obtain astonishing results. An average procedure can be done in less than 30 minutes by an experienced detailer, and the results will last up to 7 months. We've even seen results last a full 12 month on some test vehicles!
Other products if not used properly can damage the headlights or body panels. But with our kit, it's simple. There's NO need to use sandpaper like many other kits on the market.
To show you the powerful results you can achieve, we took 1996 Nissan Altima Headlights removed from a car at the local Junkyard. Here are the amazing results:
Before:
After:
Kit Consists of:
1- 4 oz Lens Cleaner
1- 4 oz Haze Remover
1- 4 oz Lens Polish
1- Micro fiber Towel 16x16
1- Applicator
1- 3” dia x 1” thick yellow foam grip pad and 1- 3" Dia grip backing plate with drill shank-to be used with a cordless drill
*Cordless drill or similar is needed, not included
Directions: (It's easy!)
Find a shaded area and proceed to wash the headlights, we prefer to use Turbo Wax Car Shampoo but I assume that any car shampoo that is PH 7 will do the job.
Step 1 - Lens Cleaner
1.Dry the headlights completely.
2.Using the masking tape proceed to cover the headlight trim area, chrome, paint, that is a safety measure to avoid any contact with your buffer.
3.Once the non working area is properly cover, proceed to spray the headlight with Step 1 "Lens Cleaner" spray the entire headlight and wipe it off using the micro fiber towel.
Step 2 - Haze Remover
4.After all the "Lens Cleaner" has been removed proceed to apply Step 2 "Haze Remover" Apply a small amount into your pad, buff the headlight surface with an even motion, apply small force to your buffer machine, make sure you buff the entire area. If the condition is extremely bad, you may have to repeat Step 2 two times. Once you have finish remove any excess with the other side of the micro fiber towel.
Step 3 - Lens Polish
5.Now you are ready for the final step "Lens Polish." Apply a small amount to your pad, you can use the same pad that was use on Step 2. Repeat the same procedure as step 2. Wipe any excess with a clean side of the micro fiber towel.
6.Remove the masking tape.
7.Now your headlights will look as new for the fraction of the cost!
to order visit
www.turbowax.com
